In uw winkelmandje: 0 Artikel, 0,00 EUR

Live Performance Super Cardioid Condenser Microphone.

The RØDE S1 is designed specifically for ‘no compromise’ live vocal performance, but has also found a place in the studio where the performer wants to hold the recording mic!

The S1 utilizes a true condenser transducer for studio quality sound reproduction. The S1’s sophisticated high pass filter dramatically reduces undesirable low-frequency background and handling noise. The super cardioid pick-up pattern further limits background noise and virtually eliminates feedback.

The multi-stage mesh head filters breath, wind, and plosive noise without affecting sensitivity or frequency response. The hardened mesh head also protects the precision transducer from the rigors of live performance. The rugged ergonomic design of the S1 makes it extremely comfortable to hold and control during use.

The S1 requires P48 V phantom supply. The high level output of the S1 is electronically balanced to reduce loss over long cable runs.

Features:
• Studio recording quality.
• Rugged all metal construction..
• Attractive satin-nickel finish.
• Heat treated high strength mesh head.
• Custom designed integral ‘plosive’ screen.
• Ergonomically weighted & balanced.
• Low noise circuitry.
• Low handling noise.
• Complete with stand mount & zip pouch.
• Designed & manufactured in Australia.
• Full 5 year guarantee.

Operation power:
The S1 is designed to operate from phantom power to the P48 standard. It may be supplied from either an external stand alone phantom supply or from a console with internal supply. The S1 will operate between 44V and 52V applied with positive polarity to pin 2 and pin 3 of the output XLR connector.

Operation output impedance:
The S1 will operate satisfactorily into a load impedance as low as 1kΩ. If a load below this is used, the output signal level will be reduced. The S1 output is balanced between pin 2 (hot) and pin 3 (cold). Pin 1 is ground.

Acoustic principle:
• Externally polarised condenser, pressure gradient transducer.

Directional pattern:
• Supercardioid.

Frequency range:
• 20 Hz ~ 20 000 Hz

Output impedance:
• 50 Ω

Signal noise ratio din iec 651:
• 75 dB (1kHz rel 1 Pa; per IEC651, IEC268-15)

Equvalent noise:
• 18 dBA SPL (per IEC651, IEC268-15)

Maximum spl:
• 151 dB (@ 0.7% THD into 1kΩ)

Sensitivity:
• - 46.5 dB re 1 Volt/Pascal (4.7 mV @ 94 dB SPL) +/- 2 dB into 1kΩ

Dynamic range din iec 651:
• 132 dB (per IEC651, IEC268-15)

Power supply voltage:
• 44V to 52V

Current consumption:
• 4.4 mA

Output connection:
• XLR 3F

Weight with battery:
• 300grm

Dimensions width:
• 183mm

Dimensions depth:
• 52mm

Dimensions height:
• 52mm

Polarity:
• A positive acoustic pressure applied to the diaphragm results in a positive voltage excursion at pin 2 with respect to pin 3 at the output XLR connector.

Maximum output voltage:
• +12.5 dBu (@ 0.7% THD into 1kΩ)